Notice - Firing Pin Safety Springs

In batches #2 and #3 there is a possibility that your firing pin safety spring is too strong and may prevent the slide from going into battery or the hammer from dropping.  That is because the extra-strong Tong spring may be in there by mistake.  We are going to send out a spring kit with hex key (and instructions) so that you can drop the correct spring under the rear sight.  I apologize for any inconvenience.  If anyone prefers, you can remove the slide assembly and send it back to us and we will take care of it.   The serial numbers that are affected are: S00064 to S00153.

Below are images of the two springs (Tong spring shown at bottom):

Here are the instructions we are sending out:

Firing%20Pin%20Spring%20Replacement%20Instructions.docx